I replaced the lower cable and cap. I pulled off the upper cable first, I assumed that was the issue being the the other pieces were new. It seemed fine. Do the make a connector that bypasses the...
Type: Posts; User: jeff
I replaced the lower cable and cap. I pulled off the upper cable first, I assumed that was the issue being the the other pieces were new. It seemed fine. Do the make a connector that bypasses the...
Pretty much what I'm thinking. 249 miles on my new angle drive :(
http://i613.photobucket.com/albums/tt212/ffeejj/DSCN10971.jpg
What causes this after 290 miles on my new angle drive? Did the drive itself fail or the cable?
I've actually found it quite difficult to buy a recovered binnacle. Vendors don't seem to carry binnacles ready to sell and the prices aren't consistent. For those of you who have purchased...
It started....................as soon as I changed the fuel filter, it fired right up!!
Double, triple and quadruple checked :) The instructions, like you mentioned are excellent and straight forward. The line I pulled off to check if it was indeed "feeding" was the hard line closest...
I'll check, thanks
Well...........new pump installed...........no start :(
I wanted to check the fuel line (to filter/engine) to make sure the new pump was actually pumping. When I pulled the line off, I was...
I did measure the depth of the tank, the pump will fit. All it would take is the rubber gasket to be a few mm too thick, I don't know.
However I did manage to get it 90% in, farther than I have...
I've tried, I crawled in the trunk and applied as much as my 180lb weight would allow....I can't get it. Twisting, pushing and swearing lol.
I thought petro based lubricant ate rubber as well,...
Can I use silicone lubricant?
This stuff specifically:
...
The rubber that goes around the pump, it sits in between the pump and the tank. The piece of rubber that goes around the "neck/top" of the pump.
Picture taken from this thread:
...
Any tricks or tips getting getting the pump into the tank? It is a super tight fit!! I'm scared I'm going to break it trying to push it down. I worked on it for an hour, and its not in.
Did...
Ahhh, thanks Dave.
It's hard to figure out and/or remember what is original when changing an after market part with a different after market part 8)
It just occurred to me......is that a factory bolt in the middle of the tank?
OK a little update. I came to the conclusion that my fuel pump is toast.
So after ordering the new fuel sender module from DMC, waiting for it, receiving it and finally having the time to install...
Thanks guys, just placed my order.
The portable battery packs work great for that kind of stuff. They have and on/off switch and you don't need a bunch of cable to hook up to the battery. Hook it up, quick on...off, simple.
I have a test light but of course it is not at home. Although I am impressed I had a multimeter though :)
Thanks Rich, got a reading of 10.58. Low but nothing to be concerned about?
Battery might be a little low, lots of cranking with no running ;)
I'm going to bump this sucker. How many of you guys are running this new set up?
I think my fuel pump is bad, or something having to do with the pump.
If I pull the white plug and apply power to the white and black wires going to the pump. The fuel pump should buzz right,...
No, the "strut tower brace"....aftermarket piece.
Never really had a chance to monkey with it this weekend. I'm going to start at the fuel pump, and go from there. I have a strut bar, how many lbs torque should it be when I re-instal? IIRC...30?
The didn't start when attaching the WUR plug to the CSV
I have tried with the gas pedal depressed.
I got called into work and I have a wedding this afternoon. I might be able to "play" with...