FRAMING JOHN DELOREAN - ON VOD www.framingjohndeloreanfilm.com

Search:

Type: Posts; User: Rich

Page 1 of 20 1 2 3 4

Search: Search took 0.05 seconds.

  1. Replies
    10
    Views
    251

    [General] With various fuel/air delivery systems and...

    With various fuel/air delivery systems and displacements the PRV was sold for >15 years in >900,000 cars worldwide. It had a solid record. In its B28 configuration the engine is understressed.
    ...
  2. Replies
    10
    Views
    251

    [General] There are some threads out there with some info...

    There are some threads out there with some info about high-mileage Ds, including this one.
    Also this one.

    Consider the age of the posts then add miles as you wish...and remember that angle...
  3. Thread: Tank varnish

    by Rich
    Replies
    20
    Views
    554

    [Fuel] +1 on the safety and disposal notes David T...

    +1 on the safety and disposal notes David T shares regarding acetone.

    I've worked with it professionally for non-automotive cleanup in a lab environment. Here is a generic acetone Safety Data...
  4. Thread: Hood release

    by Rich
    Replies
    10
    Views
    311

    [General] When you mentioned a triangle latch I thought you...

    When you mentioned a triangle latch I thought you meant the one for the engine cover. There is no triangle latch on the hood but there is a hood striker. P/N 106643.

    The diagram for all the...
  5. Thread: Hood release

    by Rich
    Replies
    10
    Views
    311

    [General] You're describing the engine cover latch and its...

    You're describing the engine cover latch and its release cable?

    Look for the release T-handle on the driver side of the rear bulkhead. It's just above the left rear wheel "bump" and just below the...
  6. Thread: Tank varnish

    by Rich
    Replies
    20
    Views
    554

    [Fuel] For the fuel varnish recovery questions - See...

    For the fuel varnish recovery questions -
    See this detailed How-To for dealing with a DeLorean's fuel system after the car has been dormant too long:
    ...
  7. Replies
    27
    Views
    912

    [General] Back to whether your coil test was done correctly...

    Back to whether your coil test was done correctly or not, you may want to refer to the factory troubleshooting guide.

    Images of the two pages you need (from Chart C1 - Ignition - Engine Will Not...
  8. Replies
    27
    Views
    912

    [General] Yes, there are two such threads: One thread is...

    Yes, there are two such threads: One thread is mainly about parts and the other thread is mainly about tools and supplies.
  9. Replies
    8,558
    Views
    1,711,213

    [General] Nice photo. From the location of your guide tapes...

    Nice photo. From the location of your guide tapes I'll guess the scratch was made by the end of the wiper arm itself, as if the wiper blade was entirely missing for at least one cycle of the wiper....
  10. Replies
    5
    Views
    259

    [General] I don't know the answer to the question. Two...

    I don't know the answer to the question. Two comments may help:

    A. Did you look for grading marks? The old ones may have their strength grade, at least if it is special-grade, embossed on each...
  11. Replies
    10
    Views
    475

    [Fuel] This vendor is right here in Northern Calif. ...

    This vendor is right here in Northern Calif. https://fuelinjectioncorp.com/
    Good to know some of our vendors approve.
    Heard about them for the first time just two weeks ago in a chat with friend...
  12. Replies
    5
    Views
    394

    [Brakes] There is a bit more to it than that. Nothing...

    There is a bit more to it than that. Nothing wrong with the posts here so far.

    Booster/servo removal/installation including optional steps for the vacuum check valve are in Section L:07:01 of the...
  13. Replies
    3
    Views
    471

    Link

    And that thread's LINK
  14. [Frame & Body] Good update on the symptoms. That's an...

    Good update on the symptoms.

    That's an interesting photo. It looks like your seal has a massively-bent U-channel in it at the top of the A-pillar. What I call the U-channel is made up of the...
  15. [Frame & Body] Another thing to check. If you pull up the inner...

    Another thing to check. If you pull up the inner sear along the A-pillar take a look along the gutter between the windshield frame and the seal flange to see if there's dirt, mud or debris jammed in...
  16. [Frame & Body] On ours with the 2018 DMCH inner door seals and...

    On ours with the 2018 DMCH inner door seals and even with prior seal designs there was always enough x-section open area at and beneath the seal body to drain the roof water. Take a look up from the...
  17. Replies
    15
    Views
    1,495

    [Heat & A/C] Refer to the DeLorean Workshop Manual. N:01:01...

    Refer to the DeLorean Workshop Manual.

    N:01:01 to N:01:09 explains how all the flaps/doors are meant to work in response the the climate control settings, specifically the mode switch and the...
  18. See Photo #1 in Post #10 of this thread. It shows...

    See Photo #1 in Post #10 of this thread. It shows the Raised White Letter side of the rear tires - just before I painted them black.

    You can also see the RWL side of the rears at the 1m20s point...
  19. A. Yes, several tire models come in 235/60-15...

    A. Yes, several tire models come in 235/60-15 size. That's not the problem. The problem is that for the past 7-8 years none of those tire models were available in 195/60-14 size for the fronts....
  20. The following fact may have something to do with...

    The following fact may have something to do with the rears being in short supply just now:

    The rears are made only in Indonesia. So if recent 235/60-15 factory shipments are sold out it may take a...
  21. Here's a bonus post about blacking out the raised...

    Here's a bonus post about blacking out the raised white letters on the Hankook Kinergy ST rears. The first photo shows the unpatterned RWL sidewall. Mounting that side inboard means the RWLs are hard...
  22. And another attempt at the photos

    And another attempt at the photos:
  23. w/photos - Review - Hankook Kinergy ST tires in factory front/rear sizes

    Re-posting the Kinergy ST tire review - this time with photos linked in, I hope.

    Hankook recently released a new line of tires in North America and perhaps elsewhere. As many owners now know,...
  24. Review - Hankook Kinergy ST tires in factory front/rear sizes

    Hankook recently released a new line of tires in North America and perhaps elsewhere. As many owners now know, Hankook Kinergy ST H735 tires are available in both 195/60-14 and 235/60-15 sizes, the...
  25. Replies
    2
    Views
    268

    [Electrical] Yes, it's probably the Bendix drive keeping the...

    Yes, it's probably the Bendix drive keeping the pinion gear on the flywheel ring after the engine fires instead of retracting it. There can be a few reasons for that, not all of which call for...
Results 1 to 25 of 500
Page 1 of 20 1 2 3 4