FRAMING JOHN DELOREAN - ON VOD www.framingjohndeloreanfilm.com

Search:

Type: Posts; User: DMC5180

Page 1 of 20 1 2 3 4

Search: Search took 0.12 seconds.

  1. [Fuel] Most of The high lift cams have base timing set...

    Most of The high lift cams have base timing set from 16-18 BTDC. But whom ever you bought them from should give you guidance.
  2. Replies
    14
    Views
    888

    [Electrical] Delorean go fuse box

    The floating fuse with 2 blue/white wires is fuse 15 (high beam). The other floating fuse is fuse 10 (A/C mode switch). Your missing fuse 13 is (Auto transmission only). It has power going to it but...
  3. Replies
    14
    Views
    888

    [Electrical] Delorean go fuse box

    Do you have any reason to believe some of your circuits donít work?

    If you just want to determine if all the fuses are getting power, just turn the key to the Run position. Take your volt meter...
  4. Replies
    6
    Views
    327

    [Heat & A/C] Check the blower motor power and grounding...

    Check the blower motor power and grounding connections at the motor.

    Itís above the passenger feet.

    Also check the Green 30 amp fuse connection.
  5. Replies
    6
    Views
    327

    [Heat & A/C] Define the heat stopped working? Hot Coolant...

    Define the heat stopped working?

    Hot Coolant flows through the heater core continuously, except when in A/C max. ( heater valve is closed )

    Does the cabin fan work or did it stop blowing air?
  6. Replies
    1
    Views
    227

    [Electrical] Help me identify this

    Thats the guts out of the glovebox light switch. The same switch is used for the engine compartment light.

    https://store.delorean.com/p-6949-light-switch.aspx

    Or
    ...
  7. [Electrical] [emoji106]

    [emoji106]
  8. [Electrical] IIRC, the flashing side marker mod makes them...

    IIRC, the flashing side marker mod makes them flash in an alternating fashion. Signal ON Marker OFF, signal OFF marker ON, etc.

    If the RH signal and RH markers flash in unison. Check for...
  9. [Electrical] This seems quite plausible. Also, since the...

    This seems quite plausible.

    Also, since the grill is removed. Consider swapping sides with the Parking/signal socket harness assemblies. This is quick way to eliminate or verify a possible bad...
  10. Replies
    62
    Views
    4,361

    [Suspension] Excess Rear Wheel Camber ????

    I view adjustable arms mostly for compensating for a lowered suspension geometry.

    Do you have any pictures of the old bushings before you pressed them out?

    Btw, you tackled this all wrong!...
  11. Replies
    90
    Views
    22,878

    [General] In stainless steel?

    In stainless steel?
  12. [General] Rob Grady has a method for doing it but itís a...

    Rob Grady has a method for doing it but itís a bit of PITA, I guess.
  13. [General] You wonít be able to remove the bushings from the...

    You wonít be able to remove the bushings from the Arm in the car. The arms a thin sheet metal that arenít boxed out. You need to make spacer fillers to keep the U channel from collapsing.

    If...
  14. [General] I think I miss read the post. I thought he was...

    I think I miss read the post. I thought he was swapping springs. I missed the UCA bushing Removal part.
  15. [General] This is not a 69 Camaro. Typically the Lower...

    This is not a 69 Camaro. Typically the Lower Ball joint is popped. The knuckle and upper CA are just tied up or strapped up out of the way. The popular method is to use the spring compressor that...
  16. Replies
    62
    Views
    4,361

    [Suspension] If, the frame to floor height is low it should...

    If, the frame to floor height is low it should also a reduced the gap in the wheel to fender opening. Nick already stated his lower cradle bottom sits well below the 5.5Ē spec. I would be curious to...
  17. Replies
    62
    Views
    4,361

    [Suspension] Excess Rear Wheel Camber ????

    Yes. Is you car parked outside or in a detached garage?
  18. Replies
    8
    Views
    669

    [Frame & Body] Iím stumped [emoji848]. Itís just not something I...

    Iím stumped [emoji848]. Itís just not something I recall seeing on the Delorean before.

    Sorry
  19. Replies
    8
    Views
    669

    [Frame & Body] Manual or automatic transmission?

    Manual or automatic transmission?
  20. Replies
    8
    Views
    669

    [Frame & Body] Looks like a rubber exhaust hanger from some...

    Looks like a rubber exhaust hanger from some other vehicle. Itís not a factory Delorean part. Itís also too clean and New looking. Where ( location ) did you discover it?
  21. Replies
    62
    Views
    4,361

    [Suspension] Post some photos of the wheel in arch.

    Post some photos of the wheel in arch.
  22. Replies
    62
    Views
    4,361

    [Suspension] Excess Rear Wheel Camber ????

    Also weird, your 245/60 tires at 33 psi should create added ground clearance. Makes me wonder if you have the wrong Coils on the shocks.

    Measure the weight on wheels coil length if you can.
  23. Replies
    8,132
    Views
    1,348,205

    [General] Thatís want adjustable control links are for....

    Thatís want adjustable control links are for. [emoji6]
  24. [Engine] Car died in parking lot after running, now won't start, will crank

    Glad you got it figured out. If I were you, I would seriously consider correcting the fuse box situation back there. The next owner will thank you. A Reproduction fusebox assembly is reasonably...
  25. [Frame & Body] What about this one: ...

    What about this one:

    https://www.deloreango.com/us/license-plate-bezel-surround.html

    However the installation seems a bit of a pain. You would have to remove the taillights to get at the...
Results 1 to 25 of 500
Page 1 of 20 1 2 3 4