Page 3 of 3 FirstFirst 1 2 3
Results 21 to 24 of 24

Thread: Assorted helpful technical photos

  1. #21
    Senior Member bfloyd's Avatar
    Join Date:  Nov 2014

    Location:  Lebanon, Tennessee

    Posts:    314

    My VIN:    3294

    Yeah... I want one of those! My engine bay light (converted to LED) stays on 24/7. My car stays hooked up to a battery tender when it lives in the garage, so no real worries about the battery running down. I could simply unplug one of the switch wires, but that would be too easy. I'm hoping DMC-Midwest has these in stock when we are up there next week.
    Barry Floyd
    Lebanon, Tennessee
    VIN 3294 - Aug. 81

  2. #22
    Senior Member
    Join Date:  Jul 2011

    Location:  Ewa Beach, Hawaii

    Posts:    132

    My VIN:    10309

    More info here from previous installation.

    http://delorean2109.blogspot.com/200...-are-cool.html



  3. #23
    Senior Member Jonathan's Avatar
    Join Date:  Jun 2011

    Location:  Canada

    Posts:    4,164

    My VIN:    3937

    Idle speed thermister (102480) location

    The idle speed thermistor (102480) is shown in this photo (not my own photo or labelling, but saved from a previous post some time ago).

    Thermistor shown in valley.jpg

    It is located underneath the intake manifold in the valley and threads into the Y-pipe. It is part of the idle speed circuit and measures engine coolant temperature. Once the engine temperature is above a "cold" set point, it provides the permissive in the electrical circuit to continue on with the normal "warm" engine logic to control the idle.

    If the electrical connector on this thermistor becomes disconnected, or isn't making a good connection for whatever reason, it can cause your engine to idle much higher than normal (~2,000 RPM). If this happens, the fix may be to get into the valley (by removing the intake manifold) and properly connecting the wiring to the thermistor.

    http://store.delorean.com/p-6749-the...dle-speed.aspx

  4. #24
    Senior Member Jonathan's Avatar
    Join Date:  Jun 2011

    Location:  Canada

    Posts:    4,164

    My VIN:    3937

    Location of fill and drain ports on the final drive

    The fill and drain ports on the final drive are shown. This is on a car with an automatic transmission.

    When checking the level of the final drive, refilling, or draining and then filling, be sure to remove the FILL port first and then once you know you can get it removed, go ahead and remove the DRAIN port.

    Final drive ports.jpg

Page 3 of 3 FirstFirst 1 2 3

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •