All right thank you very much, just sent you my address on facebook.
None of all the leds are still on.
Maybe there is a short cut on the connector?
Location: France
Posts: 2,457
My VIN: 16951
Club(s): (DCO) (DOA) (DCUK)
All right thank you very much, just sent you my address on facebook.
None of all the leds are still on.
Maybe there is a short cut on the connector?
Location: Leonardtown, MD
Posts: 9,005
My VIN: 03572
I'm surprised you did not blow a fuse. Since my wire is 22 AWG a bad connection would be in that area.Originally Posted by Domi
Location: France
Posts: 2,457
My VIN: 16951
Club(s): (DCO) (DOA) (DCUK)
The fuses are okay
It works until I moved the gear box...
So I guess the shifter plate moves a little bit and touch the connector?
Location: Leonardtown, MD
Posts: 9,005
My VIN: 03572
The plate should have alignment guides to prevent that but I just cut the pins and put some epoxy over your new one so it should not happen again.
Check that all your lights are working in case you blew a fuse.
Location: France
Posts: 2,457
My VIN: 16951
Club(s): (DCO) (DOA) (DCUK)
All right, thank you
Location: France
Posts: 2,457
My VIN: 16951
Club(s): (DCO) (DOA) (DCUK)
Thank you David for the new led board.
I start installing it with the new wires.
For safety, I have installed a 3A fuse.
Nevertheless, on my other board my leds for the lock door were brighter.
It should be the same as the defrost switch.
I wonder why is this happening, any ideas please?
IMG_9365.jpgIMG_9366.JPGIMG_9367.jpgIMG_9368.jpgIMG_9369.jpgIMG_9370.jpgIMG_9371.jpgIMG_9372.jpgIMG_9373.JPG
Location: Leonardtown, MD
Posts: 9,005
My VIN: 03572
The LEDs are the same parts. I wonder if your connection is changing the voltage sometimes. Unless I put the wrong value resistor on the board. Look at those little blue resistors to the right side of the door lock LEDs. They each should have a 1001 number to show they are 1 Kohm.
Location: France
Posts: 2,457
My VIN: 16951
Club(s): (DCO) (DOA) (DCUK)
I can't read easily, but it should be good
IMG_9376.JPG
Location: France
Posts: 2,457
My VIN: 16951
Club(s): (DCO) (DOA) (DCUK)
Took another pic with another phone, and yes it is 1001
The connection are the same as last time
The fuses are OK
If I remove my 3A fuse, nothing's work so no short circuit I guess
Location: France
Posts: 2,457
My VIN: 16951
Club(s): (DCO) (DOA) (DCUK)
If I'm not mistaken, I should have 12V between those two wires?
New Harness OEM harness
YELLOW brown/pink
ORANGE light green/white
Posting Permissions
Reply With Quote
Dave M vin 03572