Oil cooler supt brkt - 108142

[Ryan King]

Anyone have one for sale? My car doesn't have this bracket.

http://store.delorean.com/p-6306-oil...supt-brkt.aspx

[djdogbone]

Perhaps this is a DPI question

[ALEXAKOS]

Anyone have one for sale? My car doesn't have this bracket.

http://store.delorean.com/p-6306-oil...supt-brkt.aspx

If dpi does not have it... drop a pm to member eagle99-co
He has plenty used parts around

[bdmiko]

PM sent

[yellowmxwheels23]

I possibly have one from 712. I'll look when I'm at the shop tomorrow.

[Ryan King]

I possibly have one from 712. I'll look when I'm at the shop tomorrow.

Thank you. Let me know!

[Ryan King]

I possibly have one from 712. I'll look when I'm at the shop tomorrow.

Any luck?

[Jonathan]

Does anyone have a photo of this cooler bracket installed on their car?

I got under my car looking to confirm it was there and I don't think it is. Not where I would have thought it would be anyway. I'd have thought it would clamp the cooler in about the middle and then the nut and bolt would secure the end of the clamp to the fiberglass pointed at the rear passenger wheel well.

Mine looks to be held in place only by the "leaky" cooler hoses and some zip ties.

[Jonathan]

I think I found a photo showing the cooler bracket.

Leakers.jpg

I think this was made by Dave S. for showing where leaks tend to come from.

I believe the cooler bracket is shown at the high point (I might not have crawled under far enough to look up at this angle on my car to see it). I don't have that aluminum coloured wrap/insulation though on my cooler. Was that factory or did someone add that?

[DMCMW Dave]

I think I found a photo showing the cooler bracket.

Leakers.jpg

I think this was made by Dave S. for showing where leaks tend to come from.

I believe the cooler bracket is shown at the high point (I might not have crawled under far enough to look up at this angle on my car to see it). I don't have that aluminum coloured wrap/insulation though on my cooler. Was that factory or did someone add that?

That's a Grady add-on. An addition heat sink for the trans oil cooler.

Yes the bracket in question is at the left end of that cooler addition and bolts through a hole in the frame. The bracket has a welded stud and the nut goes on the other side of the frame.