...
Posts: 293
...
I like the Corvette/Camero third break light best.
image.jpg
http://pages.ebay.com/link/?nav=item...d=390974298496
Last edited by Chris 16409; 02-26-2015 at 10:23 PM.
Chris Miles
For Better or Worse I own a DeLorean!
1983 Grey Manual, VIN #16409, Fresno, California
Location: Las Vegas
Posts: 750
My VIN: 6720
Club(s): (AZ-D) (LVDG)
Definitely the C4 Corvette light. It is the only one that looks like it is stock. i have the same one on my car.
5 speed, grooved hood, grey interior (Nov '81)
QA1 coilovers, Delorean.eu LCA brackets, DPNW Poly swaybar bushings, DMCMW shock tower bar, Deloreana.com convex mirrors, DPNW Toby Tabs, DPI exhaust, C4 Corvette third brake light, PJ Grady tail light boards, Bitsyncmaster relays
Location: sacramento
Posts: 1,415
My VIN: 1768
Club(s): (NCDMC) (DCUK)
Same here, i usually have to point it out to fellow car guys. Nearly everyone thinks it is oem. I even had a die hard corvette guy admit it looks better on my car than his c4.
Check my thread below, i wrote up a how to install one.
Definitely the C4 housing. Even with the stock bulbs it looks good but I had to do better. Think I put in 108 LEDs.
Dave M vin 03572
http://dm-eng.weebly.com/
I used the 1999 GM SUV third break light way back then.
third_break_light.jpg
• 446F63746F722057686F •
I used LED side firing light strips under lip of the top
https://www.superbrightleds.com/more...-led-335/1542/
I ordered two 19" black side firing strips. Red LED's (of course) and trimmed to fit. Ran the wires to one side and had to extend the wires down the pillar above the quarter glass and to the brake lights.
Here is the result
003.jpg
Location: Middleburg Heights, OH
Posts: 1,939
I'm (very obviously ) impartial to mine, integrated into my BTTF vents:
I later changed them to light bars instead of the starburst pattern. Having them redone by my fiberglass guy at the moment though to make them both smaller and lighter (and integrated into the louvers too), will have pictures after that's complete. Here's the lighting pattern, integrating all stock taillight functions:
Location: Atlanta OTP GA
Posts: 7,084
My VIN: 2743
Club(s): (SEDOC) (DCH) (DCUK) (DOC-UK)
I assume you mean that you are "partial" to them
By "Parking" lights do you mean "tail" lights or do they have some sort of European like parking-only function?
Dermot
VIN 2743, B/A, Frame 2227, engine 2320
I don't always drive cars, but when I do, I prefer DeLoreans
http://www.will-to-live.org
No-one is to stone anyone, even, and I want to make this absolutely clear, even if they do say "carburetor"
Location: Middleburg Heights, OH
Posts: 1,939
Right you are. Mixed that one up in my head actually.
"Parking" is the same as the bulbs behind the reflector part of the taillights. I believe that's "tail"? They come on when you press the headlight switch. Basically just tapped into the stock harness.