Paris Rhone starter and solenoid rebuild kit?

[DMC5180]

Disconnect all 3 wires then probe each for 12 v. Only 1 wire is live all the time. That is the BATT wire. The other 2 are AUX and go to the 3rd and 4th speed fan relays. Configure your wires as shown in your instructions and add the Mod wire to the Empty BATT side terminal.


Sent from my iPhone using Tapatalk

[DMC-81]

Disconnect all 3 wires then probe each for 12 v. Only 1 wire is live all the time. That is the BATT wire. The other 2 are AUX and go to the 3rd and 4th speed fan relays. Configure your wires as shown in your instructions and add the Mod wire to the Empty BATT side terminal.


Sent from my iPhone using Tapatalk

Thanks again Dennis! I did this and the 4th speed connector was in the wrong spot... All fixed now.

--------------------

Here are pictures of the starter mod process..

Before mod..
image.jpg

White/yellow pigtail jumper removed from the relay block and the white/red connector removed to cut the pigtail jumper off and to move it....
image.jpg

After mod..
image.jpg

The other end of the mod wire attached to the BATT terminal of the fan speed circuit breaker..
image.jpg

Also, I finished up the starter and protection plate. Before and after...

image.jpg image.jpg

This task is now finished. Thanks to everyone for your help (and parts).

[Morpheus]

Looks great, as usual!