Robert
People they come together, people they fall apart...
Thanks. Anyone know what size the larger 2 vacuum hoses are on the back sides of the intake? Figured might as well replace them too while I'm in there. I think the smaller stuff is 5/32".
Jeff
Spent some time yesterday cleaning the VOD more. Those deep galleys are a real pain to get clean. I took my pic set and dug around in there. So far everything looks good. I don't see any evidence of block rot, which was my biggest fear. I know its been asked before but what causes that? Bad mix of metal/aluminum the day a particular block was cast?
I plan on at least one more round of cleaning before I start replacing seals and doing the reassembly.
VOD.jpg
Jeff
Is there a particular order these vacuum lines from the thermal vacuum switch need to be run in the pic below? I know the 3 locations, just curious if the order matters. I wouldn't think so unless there's an internal wall or something in there...
IMG_0581.jpg
Jeff
Location: Taylors SC
Posts: 5,326
My VIN: (former)05429
Club(s): (DMWC) (DCUK)
Dave S
DMC Midwest - retired but helping
Greenville SC