I could probably figure it out if I had the unit here but maybe someone else has already done it. Do an internet search to see if someone posted the interface.Originally Posted by 81dmc
Location: Leonardtown, MD
Posts: 9,008
My VIN: 03572
I could probably figure it out if I had the unit here but maybe someone else has already done it. Do an internet search to see if someone posted the interface.
Location: FL
Posts: 948
My VIN: Early
Today, I installed the display between the speedometer and tachometer. It looked a little too bright, so I fixed that further down the post.
Wiring through a hole drilled into the bottom.
SEM Trim Black and a heat gun later...
Look better?
How about a test of the display?
Hmm, closer, maybe?
The display ran perfectly when connected to the 12v wire from the old OEM PRND21 indicator. I think I'll just use simple relays and hide them next to the shifter housing in the frame.
Early 81 5spd conversion- DMCH Ground Effects, Double Din, Custom Instrument Cluster, QA1 Suspension, 3.0 PRV with MS3
Location: FL
Posts: 948
My VIN: Early
Gear indicator done!
BTW, how do we post youtube videos here?
Last edited by 81dmc; 03-25-2016 at 05:36 PM.
Early 81 5spd conversion- DMCH Ground Effects, Double Din, Custom Instrument Cluster, QA1 Suspension, 3.0 PRV with MS3
Location: FL
Posts: 948
My VIN: Early
Never mind, already figured this out.
Early 81 5spd conversion- DMCH Ground Effects, Double Din, Custom Instrument Cluster, QA1 Suspension, 3.0 PRV with MS3
Posting Permissions
Dave M vin 03572
Reply With Quote
