I found the windows switches much easier to refurb than the defroster switch. I used a fiberglass scratch pen which allowed me to clean the contacts without much disassembly. I cleaned both switches and took pics in about 20 minutes.
These get funky because they lack real high current contacts and the brass center terminal becomes burned.
Tools used:
-Xacto knife
-Small flat blade screwdriver
-Fiberglass scratch pen
-Thick cardboard or a business card
-Naptha, WD40, or contact cleaner
Step 1:
Remove the switch cap
Cut the plastic rivets that hold the switch body halves together.
01.jpg
Step 2:
Pry the case halves apart but be sure to keep the switch parts held into the larger switch half. I held my thumb over the terminals while slowly working the case apart.
02.jpg
Step 3:
Remove the middle terminal and burnish the contact area with the scratch pen.
In this image you can see how discolored the contacts get.
03.jpg
04.jpg
Step 4:
Burnish the moving contacts with the scratch pen
05.jpg
Step 5:
Clean the lower and upper contacts with naptha and cardboard until black marks on the cardboard are no longer created. The uppers will probably not show much wear but will still probably be dirty.
06.jpg
07.jpg
Step 6:
Replace the middle terminal.
08.jpg
Step 7:
Reassemble the case and make sure the upper contact bar is captured by the case correctly. I used a spot of super glue where the rivet heads were cut off to keep the case locked together.
09.jpg