Hey I just picked her up, And she ran fine but needed a heater core, and water pump
I had to replace the water pump so I took all the usual stuff apart. Also changed the cap, rotor and plugs and she doesn't run now that I put her back together.
-Also I checked the plug arrangement and verified they were going to the correct cylinders.
- I have spark coming out of plug touching the intake
-The resistors on the firewall show 8.54-9.3 Vdc
-Pulse Coil shows 600ohms resistance
-Ignition coil with key on shows a dim light on my test light
-Verified fuel comes out on inlet line on the CIS system
-Verified that the CIS arrangement is correct (lines,freq valve, cold start, wur valve etc)
- All fuses are good.
Im stumped, what could it be??? she turns over just will not run. I did take the dash apart to redo the heater core could that be it?
Thanks guys