Location: Reedsburg, WI
Posts: 4,026
My VIN: 5180
Club(s): (DMWC) (DCUK)
I just wondered because it didn't look like heads had been removed.
Sent from my iPhone using Tapatalk
DENNIS
VIN 5180, Frame 3652, STAGE II, DM-eng Solid State Solutions (RPM Rly, Dm.Lt.Mod., Fan Fail Mod. , FAN Rly, HS.Rly) , HID headlights, SPAX user since 2009, Eibach springs, M Adj. Rear LCA's, DPNW poly-sway bar kit, DMCEU LCA Stabilizer link kit, DMCMW Illuminated door sills, Aussie Illuminated SS Shifter plate, REAL MOMO EVO Steering wheel, DELOREANA Extended View Side Mirrors w/ Heaters, DELOREANA LED Door Lights.
Location: Rochester, NY
Posts: 2,405
My VIN: 01049
Location: Fort Lauderdale
Posts: 4,740
My VIN: 02613
Club(s): (DCF)
Yes.
I keep trying to put photos inline, but it keeps failing. Probably something to do with my browser or Flash. Anyway, here are two attached.
Engine accessories have been fitted: a/c compressor, water pump, and alternator. Serpentine belt is installed. Everything looks good.
Alternator is in the stock position for the 3.0L engine; as a result, that wiring had to be replaced with a longer run.
New engine mounts have been installed.
Engine compartment is ready for installation.
Farar
Last edited by Farrar; 05-05-2017 at 02:45 PM. Reason: forgot a very important word. oops
3.0L, automatic, carbureted
Location: Illinois
Posts: 2,440
My VIN: 11408
Club(s): (DMWC) (TXDMC) (DCUK) (DOI)
I did something similar as well. stupid design with some orings and a spring.
Supercharged 5.3L LS4 + Porsche 6spd
[email protected]
lsdelorean.com
I am not affiliated with Delorean Midwest in anyway.
Location: Farmington Hills MI
Posts: 359
My VIN: 2203
Club(s): (SEDOC) (DCUK)
Do you know if a 2.8L (K-Jet) manifold will fit on the 3.0L?