Contact info for Delorean upgrade parts ? Byrne H ?

[Lou and "Boo"]

I am trying to contact Byrne (or whomever is running his company now) because I bought a set of window motors from him and neither I nor my buddy (who rebuilt/restored 3
Deloreans) can figure out how they can possibly mount in the door.

If anyone can post or pm me with the contact info I would greatly appreciate it. I cannot find any contact info on the
New Website.

[DMCMW Dave]

a set of window motors from him and neither I nor my buddy (who rebuilt/restored 3
Deloreans) can figure out how they can possibly mount in the door.
.

Pictures? I've only ever seen one aftermarket window motor style and they fit (with a bit of effort).

[Lou and "Boo"]

Dave , out of respect for Byrne I hesitate to post pics of the motors. He sent me them as he was dealing with his health issue and he decided to close shop.

I will pm you pics and then maybe you can give me some advice . Thank you

[Drive Stainless]

Byrne told me himself that he is not closing shop. Why not post the pics?

[Lou and "Boo"]

Ok maybe someone on her has Byrnes window motors and can offer any installation guidance. There are no threaded holes (or any holes) in the unit to screw the mounting plate to. The plastic sleeve is connected to my OEM metal sleeve that I sent him by a 2 inch section of fuel hose and tpits just shoved in there and easily falls out. There are no mounts at all and nothing along the tube either except for a peice of carpeting insulation on one of them , maybe that's supposed to hold the screw?

[Lou and "Boo"]

image.jpg
image.jpgimage.jpgimage.jpgimage.jpg
image.jpg

I can take better pictures in the sunlight tomorrow . The cable inside that rides the gear is very short too.

[Lou and "Boo"]

When I asked for installation instructions or
Pictures Or Diagrams , Byrne emailed me back and just told me that they are smaller than the stock ones and that he installs them on every car he sells. He told me about the drivers and passenger side markings which I already knew. He is very vauge and non technical . His email did not help at all. But there are no places to mount a bracket of any kind. I showed these pics to Dave Swingle and he is perplexed by it too.

[Lou and "Boo"]

I asked Byrne again about how the motors attach to the door brackets and this is his reply. Again, very quick vauge and non technical and again not answering my question at all.
The bottom is my question and the top is Byrne's reply.


Good morning Louis,
Insert the regulators such as the two eye let holes attach to the two Pins on the door window.

I insert the long end in first to ward the front of car and then the rear short end.

Thanks,

Byrne


On Sunday, August 21, 2016 9:20 PM, louis duet wrote:


Byrne, I hope you are doing well. How do I attach the motor assembly to the bracket and mount into the door? Can you please provide me with some kind of pictures or illustrations? There are no bolt holes anywhere on the Unit to attach it to anything. I do notice the drivers and passenger Side markings but the actual casing cannot attach to the mourning bracket. Please see the pictures I sent. Can you link me to others who have installed them successfully so I can see how they attached the motors to the doors?

Thank you again ,
Louis Duet