This is going to take a while.
Sent from my iPhone using Tapatalk
This is going to take a while.
Sent from my iPhone using Tapatalk
Location: Happy Valley, OR
Posts: 1,709
My VIN: 4456 - Owner since March 2011
Club(s): (PNDC)
What are you going to cast them out of? Silicon?
Cheers
Steve
Cheers
Steven Maguire
#4456
IT'S A TRAP!!!!!
Next up is an idea I had for mounting the flux band brackets. I'm suspending hard drive magnets just inside the mold so they will be slightly under the bottom of the bracket.
Now the Reoflex goes in and wait 16 hours!
I'm testing on the front fender since it's easy to get magnets behind the stainless.
Now the bracket will stick to the car!
I'm not sure if this will be strong enough to hold while driving. I guess once they are all on the car I'll have to see how much force it takes to pull them all off. I have a feeling I will need to fasten them to the car somewhere for safety....time will tell.
Now on to make a crap load of these....
Next up, flux boxes!
Sent from my iPhone using Tapatalk
Location: Happy Valley, OR
Posts: 1,709
My VIN: 4456 - Owner since March 2011
Club(s): (PNDC)
Cheers
Steven Maguire
#4456
IT'S A TRAP!!!!!
Lookin good so far Steve!
Posts: 3
Looks great so far! I'm excited to see your progress on the magnets. Great idea!
Nice work so far, and I like the idea of the magnets too- once you have those all in place under the skins they might hold fine as the load is being spread out.
As far as the flux boxes, I was considering modeling them in Fusion 360, hollowed out, and then 3D printing in a couple sections so they're lighter than resin boxes - same goes for the Wormhole Emitter I modeled. Can't wait to see your progress. If I can get close enough to another time machine replica, I might do some 123D catch to get some good 3D scans and then I can print out most of the hard to find parts, like the pucks, etc.
I think I am finally ready to make some molds. The oil separator model (thanks Steven Maguire for the measurements and pics) has removable dowel pieces for the pipes so I will just mold the base. Question now is what material should I use for casting. I'm thinking it would be good to tint the material the blue/gray for the boxes and of course black for the oil separator.
Sent from my iPhone using Tapatalk