Results 1 to 2 of 2

Thread: Cylinder Head Variances.

  1. #1
    Senior Member DMCVegas's Avatar
    Join Date:  Oct 2011

    Location:  Las Vegas

    Posts:    2,426

    My VIN:    6585

    Club(s):   (DOA) (DCUK)

    Cylinder Head Variances.

    Does anyone have pictures of an 3.0L PRV Cylinder Head from the Eagle Premier? Even better, measurements?

    1. I'm wondering if there is a boss that can be drilled out to accommodate a 2.8L Electrical Distributor.
    2. How much different are the sizes/locations of the intake ports to accommodate different manifolds?

    Board Member, DeLorean Owners Association

    Recording Secretary

  2. #2
    Owner since 2007 Farrar's Avatar
    Join Date:  May 2011

    Location:  Plantation, FL

    Posts:    4,398

    My VIN:    02613

    Yes, it is possible to drill for and install a traditional ignition distributor on the 3.0L engine. But you will need to swap in a 2.8L camshaft to turn the distributor. The 3.0L camshaft has no gear in that location.

    Edit: I guess a picture would help. Here you can see there is a hole there, but it doesn't go all the way through. The hole is about 7/8" in diameter. You can also see there is a smaller hole where a fastener would go for a distributor clamp.

    Last edited by Farrar; 03-10-2017 at 01:15 AM.
    DeLorean status: Whatever.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts