An interesting potential update to the DeLorean
Location: Las Vegas
Posts: 148
My VIN: 4675, 4190, 3114 and others
Club(s): (DMA) (DMWC) (NCDMC) (DCUK)
An interesting potential update to the DeLorean
Very interested
Steve
#01785 '81 DeLorean, Automatic with fuel flap & Black interior
There is not much I can do about reducing wiring changes. The side lights need to have power to flash when the lights are off. And I turn the ground side of those side lights on and off to make them flash.
I have almost caught up on other things so I did start entering the schematic and ordered some parts.
Dave M vin 03572
http://dm-eng.weebly.com/
Location: Chicagoland
Posts: 158
My VIN: 10322
Club(s): (DMWC) (DCUK)
I'd be up for it. I would just need a lot of walkthrough. I always drive with all of my lights on because I heard it reduces your chances of an accident by like 5% (not DeLorean study, I assume it was Honda Civics?).
http://www.artgemsjewelers.com/
Fine Geek Jewelry.
If the above post was DeLorean related it should be noted that I don't know what I'm talking about.
Tumblr: Going88 || Instagram: Going.88
I have a board (PCB) laid out. I tried to look for screw terminals to install on the board but then because those are so large, I could not just have the board covered with heat shrink.
So right now I just have 4 through hole pads (for 16 AWG wire) laid out on the left side and 4 also on the right side (for the side lights + and - wires). The left side is left blinker, right blinker, lights and ground.
I'm using Schottky diodes so the voltage loss should only be about 0.2 volts with LED side lights and 0.4 volts with incandescent side light.
My plan is to solder about a foot of wire into each of the 8 holes. So the user would not have to solder but use crimp splices to his harness. I could also sell without the wires if you want to solder your own into the board.
If you have any other suggestions, let me know. I may get one prototype which cost me about $75 or just get 100 production boards which cost $425.
Dave M vin 03572
http://dm-eng.weebly.com/
Location: Flekkefjord, Norway
Posts: 128
My VIN: # 00712 (ex-Howard Hughes) # 03692 # 03980 # 05414 # 06759 # 06833 # 06975
Club(s):
I'm interested Dave, will probably order a few sets from you when they're ready.
Stian Birkeland
Norway
100 boards ordered this morning. Will take about 2 weeks to receive them.
Dave M vin 03572
http://dm-eng.weebly.com/