Looking to contact Mike regarding his digital dash.
I want to talk about his connector for the original wiring to the instrument cluster.
If anyone has his phone or email I would really appreciate it.
Thanks
Posts: 24
Looking to contact Mike regarding his digital dash.
I want to talk about his connector for the original wiring to the instrument cluster.
If anyone has his phone or email I would really appreciate it.
Thanks
I haven't seen or emailed him in a few years.
The last email I have for him is mike [at] nrdvana [dot] net
Shannon Y
www.ohiodeloreans.com
www.facebook.com/ohiodeloreans
---
1st angle drive - 58,027 miles (20 years) -- original
2nd angle drive - 48,489 miles (21 years) -- original from donor
3rd angle drive - 26,572 miles (2 years 3 months) -- DMCH
4th angle drive - 21,988 miles (1 year 11 months) -- DMCH
5th angle drive - 7,137 miles (10 months 2 days) -- DMCH
6th angle drive - OVER 113,704 miles and counting (OVER 13 yr 1 month & counting) -- new Martin Gutkowski unit
over 245K miles
Location: Pittsburgh, PA
Posts: 504
My VIN: Yes.
Club(s): (DCO) (DMA) (DCUK)
Maybe you want to talk to Kevin Krinn. He is still very much working on his.
Posts: 24
Posts: 24
I emailed to the email address.
It was not rejected so the account is still active.
Hoping for a reply.
If he happens to attend the DCO Annual Meeting in April, I will tell him about this thread.
Shannon Y
www.ohiodeloreans.com
www.facebook.com/ohiodeloreans
---
1st angle drive - 58,027 miles (20 years) -- original
2nd angle drive - 48,489 miles (21 years) -- original from donor
3rd angle drive - 26,572 miles (2 years 3 months) -- DMCH
4th angle drive - 21,988 miles (1 year 11 months) -- DMCH
5th angle drive - 7,137 miles (10 months 2 days) -- DMCH
6th angle drive - OVER 113,704 miles and counting (OVER 13 yr 1 month & counting) -- new Martin Gutkowski unit
over 245K miles
Posts: 24
I got a hold of him through his email.
Thanks everyone.
I hope to be able to use his connector for my digital dash.
I am using the Create a Dash kit from https://www.intellitronix.com/ Part # BG10003
I will have to add a 3 pin connector for the digital speedometer, but everything else will be handled through original wiring and plugs.
I think I have a solution to the battery bulb in the cluster.
I will be replacing it with a LED and moving the bulb to the engine bay. I then monitor the bulb so that if the bulb is lit the LED is lit and if the bulb is off the LED is off.
This way the alternator and bulb works normally and the bulb is easy to replace if if ever burns out.