Location: Leonardtown, MD
Posts: 9,005
My VIN: 03572
+1Originally Posted by Patrick C
Heat will often activate the glue again. Might be safer to use an iron set to low temp. I have a small iron I used to shrink MONOKOTE which is a plastic covering for radio controlled airplanes. That iron has a better temperature setting range.
Location: Connecticut
Posts: 29
My VIN: 3469
On my earlier car on the drivers side they are getting beat up. What is that piece called so I can see if DMC has new ones?
Location: Vancouver, BC
Posts: 3,385
My VIN: thirty two 'o five
Club(s): (PNDC)
The "bolsters" (I think thats what they're called) are part of the trim panel, if thats what you're referring to. Drivers side trim panels are extinct. Just buy the caps. They're a good, cheap alternative.
Dave
Here, somewhere.
Posting Permissions
Dave M vin 03572
Reply With Quote