Hey guys.
It's been a while since our last tech day. I just moved into a new house (yes yes I do that way too often), and I'm thinking of hosting one for Spring. How many of you might be down for something sometime in the beginning of May?
Location: Atlanta-ish
Posts: 2,218
My VIN: 5311
Club(s): (SEDOC) (DCUK)
Hey guys.
It's been a while since our last tech day. I just moved into a new house (yes yes I do that way too often), and I'm thinking of hosting one for Spring. How many of you might be down for something sometime in the beginning of May?
- Chris
what
Location: Farmington Hills MI
Posts: 359
My VIN: 2203
Club(s): (SEDOC) (DCUK)
Sounds good to me!
Posts: 2
In what area would this be held? I'm a new Delorean owner and new to the forum
Sent from my iPhone using Tapatalk
Location: Atlanta OTP GA
Posts: 7,084
My VIN: 2743
Club(s): (SEDOC) (DCH) (DCUK) (DOC-UK)
Chris is in the suburbs of Atlanta, if you are in the area KP.
I want to see this new house and get some stuff notarized
Dermot
VIN 2743, B/A, Frame 2227, engine 2320
I don't always drive cars, but when I do, I prefer DeLoreans
http://www.will-to-live.org
No-one is to stone anyone, even, and I want to make this absolutely clear, even if they do say "carburetor"
im down and this time you guys cant send me away for having a painted car
Location: Farmington Hills MI
Posts: 359
My VIN: 2203
Club(s): (SEDOC) (DCUK)
This could be 2203's first tech day.
Dana
1981 DeLorean DMC-12 (5 Speed, Gas Flap, Black Interior, Windshield Antenna, Dark Gray)
Restored as "mostly correct, but with flaws corrected". Pictures and comments of my restoration are in the albums section on my profile.
1985 Chevrolet Corvette, Z51, 4+3 manual
2006 Dodge Magnum R/T (D/D)
2010 Camaro SS (Transformers Edition)
Location: Douglasville,GA
Posts: 5
My VIN: SCEDT26T6DD016438
Last edited by delorean16438; 04-10-2017 at 12:05 PM.
Ill be showing up with my DMC. I need to change out my crossover pipe, but dont think that's feasible on a Sunday. I have to drive back Alabama cutting my time short.
@RamblinDMC: Im going to try to actually test out my shift plate design so that if it fits, you can cut out the real one and just bring it to the meetup.