So today I re adjusted my door latches per the factory spec AGAIN.... it seems as though my lock bell crank just does not like to unlock all the way after the door is manipulated a few times. I have no preload or free play in any latches, the locks are the same no free play/pre load. The one that seems to be a PITA is the front lock rod, it seems to get hung up. I looked down in the door at the lock part and it seems to get hung up sometime when manipulating the lock. My question is can you lubricate the actual door latches/locks? or am I just being an idiot and need to keep at the adjustments. I also think I have a bad solenoid because the pin loves to go out but not retract in all the way and I noticed this also will mess with the lock rods. Is there a possibility of having a bad latch/lock bell crank? my door locks do not work electronically, I have cleaned/checked all wiring in the doors. I know the roof box can have bad wiring, I also have a rebuilt lock module (factory). I have noticed that my intertia switch looks like its been kicked by a foot at some time because its cracked wonder if its messed up some how, it has a dab of white paint on it? wonder if its the original one..... my car has just over 100k on her.