Hi all-so I've got 4 new stainless steel brake lines installed, as well as a new master cylinder. I think I'm ready to re-bleed the entire brake system, and wondered if there's any tips, as this is my first time doing this job.

I've done some research on bench bleeding the master cylinder, and am not sure if this is relevant, as the diaphram was not removed from the car. thoughts on that?

And I've got a pressure bleeder I've purchased, so I should be able to do this myself. Would it be ideal to do one line at a time? It looks like folks sometimes leave all 4 valves open initially, then close them off and fine tune each line. Thoughts on that, as well?

Thanks much for the help!!