Location: Sacramento-ish
Posts: 4,408
My VIN: 02100
Club(s): (NCDMC) (DCUK)
Thanks, Christian. Will check it out tonight.
Hey, I just got the Mattaligner and there is a drill bit included. Not sure what that could be for. There are two small holes in the plate but I'm not sure what I'm supposed to do with those - no instructions in the box. What am I drilling? What am I attaching? No hardware was included.
Jon
1981 DMC-12 #02100. July 1981. 5-speed, black, grooved w/flap.
restoration log, March 2011 to present
full and detailed photo restoration log
Location: Allen, TX
Posts: 68
My VIN: #4595
This link has instructions for installing the Mattaligner. I have one waiting to install right now and it looks very straightforward.
http://www.awildermode.com/2016/10/t...ainer.html?m=1
Good luck!
Location: Sacramento-ish
Posts: 4,408
My VIN: 02100
Club(s): (NCDMC) (DCUK)
Yeah, never mind. I'm a dolt. There were a little baggie of screws sliding around in the box, which I found later. Once I found those it was pretty clear what to do, and I have to say that is a really primo part. Installed easily and the switches are perfect now. So tightly installed and aligned, and it even straightened up the console a bit, when I didn't even realize it needed it!
Jon
1981 DMC-12 #02100. July 1981. 5-speed, black, grooved w/flap.
restoration log, March 2011 to present
full and detailed photo restoration log
I was just gonna reply and read this! No big deal. I thought the same thing a year ago lol
Sent from my SM-N920P using Tapatalk
Vin 11035 wide stripe, flat hood, 5 speed, Spec 1 exhaust, custom grey/black interior, custom lighting, custom stereo and custom alot of stuff!