Page 6 of 6 FirstFirst ... 4 5 6
Results 51 to 52 of 52

Thread: Proofing my work after fuel distribution re-assembly?

  1. #51
    Senior Member Bitsyncmaster's Avatar
    Join Date:  May 2011

    Location:  Leonardtown, MD

    Posts:    6,722

    My VIN:    03572

    My guess would be your temp sender has a bad connection. You can jumper that sender at the idle ECU to test. Or the ECU itself is bad.
    Dave M vin 03572
    http://dm-eng.weebly.com/

  2. #52
    Delorean Guru
    Join Date:  May 2011

    Location:  Northern NJ

    Posts:    6,237

    My VIN:    10757

    Club(s):   (DMA)

    If the idle changes without touching the throttle it could be a "hicccup" in the idle motor system from a bad connection. Make sure the throttle decel springs are not burnt up too. Doubt it would be the temp sender for the idle ECU, it is not supposed to be able to change the idle that much.
    David Teitelbaum

Page 6 of 6 FirstFirst ... 4 5 6

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •