Page 2 of 2 FirstFirst 1 2
Results 11 to 12 of 12

Thread: Fan Speed 4 is no go. 1, 2, 3 work!

  1. #11
    Senior Member Nuclearbacon's Avatar
    Join Date:  Jun 2012

    Location:  Santa Cruz, Ca

    Posts:    194

    My VIN:    10588

    Club(s):   (NCDMC) (DCUK)

    Ladies and gentlemen, boys and girls. My 4th speed relay is bad.

    I changed my wiring to the correct configuration and I had speeds 1, 2, 3 but no 4. Swapped relays and I had speeds 1, 2, and 4! No 3. My 4th speed relay is DOA.

    Anything fancy besides direct replacement? All my relays say "DMC 2011"

    Thank you all! Fantastic! Again, I love this forum!
    -Luigi-
    Thank you ALL for your patience and your tremendous help!

    1982 VIN#10588 Build Date Dec '81

  2. #12
    Delorean Guru
    Join Date:  May 2011

    Location:  Northern NJ

    Posts:    6,203

    My VIN:    10757

    Club(s):   (DMA)

    You should check with your favorite vendor and if necessary buy the relay upgrade kit along with a new 4th speed relay. You should also check the fuses to see that the correct size fuse in each position. Add a 10 Amp in-line fuse to the door module in the big red wire if you are still using the original door lock module. Make sure there is nothing plugged into the hot start relay plug. Look for signs of heat damage especially around fuse #7 and the fan fail relay. If the blue fan fail relay is still there get it out and get a Fanzilla, the bypass wires, or something else.
    David Teitelbaum

Page 2 of 2 FirstFirst 1 2

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •