I replaced my angle drive, dust cover, and lower cable in hopes of my speedo failure would be solved. Apparently I fall into the 10% of speedo problems not resolved by replacing those. I suspect it is the speedo itself since running a drill on the shaft in the upper cable doesn't move the needle.

Regardless, I hope the speedo can be repaired by some local shop specializing in such things.

The question I have is that the angle drive shaft appears to be about 2mm or3mm too long, and the dust cover is hard to get into a well sealed position. I've ensured its seated into the AD, but still just a bit too long.

Is this a common problem, and if so, any advice?

Thanks
Steve