FRAMING JOHN DELOREAN - ON VOD
www.framingjohndeloreanfilm.com
-
Senior Member
-
Senior Member
After a quick search, I'll be getting some permatex silicon tape to wrap around the hoses where melted belt material had been hitting.
-
Administrator
FWIW, I'd change out that hose in the last pic over what looks like a nick/gash on the bottom side.
-
Senior Member
I'll be changing both hoses going to the water pump. I daily drive the car so I need something temporary until I can get the parts and change them out. I also want to fix the problem that cause the nick before changing it out so I dont have to replace it again.
-
nick
I just put a hose clamp for the belt to rub against.....
-
Senior Member
-
Senior Member
Stopping point for this weekend. Left the AC belt off cause idler pulleys are misaligned. Still not sure how to check alignment for alternator pulley. If the water pump pulley was flat on the front then i'd get it easy. Still got plenty left to clean on the engine, but the rear is as good as I could reasonably get it.
-
Senior Member
I forgot I worked at a manufacturing plant. I scored a lot of 100 grit silicon carbide sandpaper from our board sander. Hopefully it does the job for getting the grain and scratches out for the mirror polishing.
-
Senior Member
Got these done as freebies from the local powdercoater
-
Senior Member
It's been a while since I posted, but my car is now paid off and I just got the title in the mail!
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules