Posts: 72
Doing some routine maintenance on my passenger door. Removed interior panels and found two empty holes (with black sealant) at the bottom front. The door and window all work fine. On other photos from various websites these two holes are also empty with no bolt or screws in them? Should there be something attached here? Just curious...
20180129_140018_resized.jpg
20180129_140035_resized.jpg
Robert
Belfast
Vin #3915
Location: NYS
Posts: 2,511
My VIN: 4519
I think those are where the bottom of the OEM window motor bracket attached. Is that a replacement window motor?
This thread shows a pic of the OEM bracket (post #1, pic #5.) http://dmctalk.org/showthread.php?82...t=window+motor
Last edited by Rich_NYS; 01-29-2018 at 11:30 PM.
Location: Florida
Posts: 2,371
My VIN: <2000
Club(s): (DCF)
Agreed. Here is my same door before I removed the original window motor. It had the same black RTV.
I only reused one of the two holes with my A1 replacement motors:
Afterwards, I just filled in the unused hole with RTV again.
Dana
1981 DeLorean DMC-12 (5 Speed, Gas Flap, Black Interior, Windshield Antenna, Dark Gray)
Restored as "mostly correct, but with flaws corrected". Pictures and comments of my restoration are in the albums section on my profile.
1985 Chevrolet Corvette, Z51, 4+3 manual
2006 Dodge Magnum R/T (D/D)
2010 Camaro SS (Transformers Edition)
Posts: 72
I bought my car in Kansas MI in 1990 and a previous owner must have replaced the original power window motor hence the two empty holes. Mystery solved. Thanks guys.
Robert
Belfast
Vin #3915
Posting Permissions
Reply With Quote