Ok....here is what I did today.
1) Cut off all the wire connectors at the ballast resistor, and installed new connector terminals. I also cleaned the ballast resistor. Reinstalled the wires back on the resistor in the correct order. I still could not start car.
2) Cut off blue/yellow wire connector at the starter. Installed new connector terminals and cleaned the starter terminals. There was also another wire there I installed new terminal and cleaned that one as well. I still could not start car.
3) unplugged the cold start valve plug and used the plug from the warm up regulator. I still could not start car.
4) I made a wire jumper with a alligator clip on both ends. I attached one end to the coil + lug and the other to the positive jump start lug. I still could not start car.
5) I jumped the RPM fuel relay so the pump would run. I still could not start car.
6) As a last resort I pulled the air filter box and sprayed 2-3 shots of starting fluid into the manifold. The car still would not start.
Can someone please help me out as what to check next.....
Thanks a million!!!