I've wanted to do this for a while and last night was enough for me - third broken cables in 16 years. I took about 30 minutes to install this electric release and it works pretty damn great. I had to cut the cable support off the bracket, I then installed some riv-nuts and bolted the motor down, it doesn't require attaching on the top of the mount- the way it's installed is perfectly sound. I do plan to install some kind of manual release should this fail but I am still working that out. Same with the release switch placement - working out where to place two of them; I will install the same motor to make the engine cover an electric release as well, this weekend hopefully.