I have stripped the interior out of the car today, and gotten 99% of the old foam sound insulation out (goof off is fantastic at helping get the old foam and glue residue out BTW)
I'm about to install dyamat, a Hervey foam insulation kit, and the DMCH carpet kit that I've had sitting around for a while. I have a couple of questions:
Dynamat everywhere? I have plenty. I'm thinking I'll put it in under where the foam will go on the firewall and parcel area, on the face of the plywood panel behind the seats, on the wheel arches and around the factory speaker locations under the removed plastic armrest panels and as much of the tub and tunnel as possible. Anywhere I shouldn't put it? I'm guessing that putting dynamat on the top side of the tunnel will screw up getting the center console on properly?
Assuming I put it down on the fiberglass in the firewall area, no problems then gluing the foam soundproofing onto dynamat - right?
Is the dynamat going to create any clearance problems?
I have a can of headliner glue - is that the same thing as carpet glue or do I need to go hunt that down?
Any advice appreciated...