Hey all, recently got my car back but while waiting for my title to come to me from california ive been starting the car every 3rd day. I recently installed the auto air bleed kit from Toby. I have seen the temp gauge work, and was venting the air to get all the air out of the system. It was a pretty cold night but i let the car idle and went for an around the block drive for about 15 minutes and the temp gauge did not budge at all. I figured the temp sensor could possibly either A: not be connected or have come loose , or B: its gone bad( i doubt and i believe i had it replaced in 2014 when i first became the new owner). Regardless While trying to get a good angle to look at the temp sensor without removing the air filter, i found a connector thats disconnected. Does anyone know what connector this is? I looked at pictures of the temp sensor and figure its probably a single spade connector but does anyone know what color the wire itself is? Thanks for reading my long post!