Reproduction mirror switch project

[Rhye]

I know, I'm a bit late - a link to the user manual for switch V1.31 attached:

https://drive.google.com/file/d/1s7F...ew?usp=sharing

[MrChocky]

I know, I'm a bit late - a link to the user manual for switch V1.31 attached:

https://drive.google.com/file/d/1s7F...ew?usp=sharing

Typo:

"undoing it’s bayonet coupling." *its

[Rhye]

Typo:

"undoing it’s bayonet coupling." *its

Corrected - thanks.

[Alan]

Rhye,

These look every good as I'd expected with you "in the driver's seat." I was afraid you were only going to do your initial run of 4. I'm thrilled that you're alluding to another run later this year. Do you have a list for the next run? If so can you let us know who's on it? If not, can you start one... I'd like to be on it.

Thanks,
Alan

[Rhye]

Rhye,

These look every good as I'd expected with you "in the driver's seat." I was afraid you were only going to do your initial run of 4. I'm thrilled that you're alluding to another run later this year. Do you have a list for the next run? If so can you let us know who's on it? If not, can you start one... I'd like to be on it.

Thanks Alan. I've got you on the list, as well as everyone who expressed interest on this thread or through PMs.

[D Knight]

Has there been any progress made on these? Still interested.


Sent from my iPhone using Tapatalk

[Timeless]

Anyone using this?

https://store.delorean.com/105085b-e...placement.html

[Rhye]

Has there been any progress made on these? Still interested.

First of all, I'm still missing feedback from the first users so there might be something worth improving that I'm still not aware of.
Most of the internal parts design changes (mostly to eliminate gluing of the joystick pad) are done and partially tested. A new method of illuminated symbol fabrication is still under development - this is the biggest blocking point at the moment.

[Rhye]

Just letting everybody know that the project is still alive and progressing. The V1.32 batch is almost assembled - except the epoxy clearcoat and illumination. 5 pcs should be ready till mid September.

Main differences compared to V1.31:

- laser-engraved PMMA decal insert (similar to the one on the 3rd photo)
- resettable polymer fuse on PCB
- original RISTS plug instead of a 3D-printed one

IMG_20220806_175743739.jpg IMG_20220806_175933849.jpg

IMG_20220806_180851637.jpg

[D Knight]

Cool. Good to hear.


Sent from my iPhone using Tapatalk