Leaky coolant hose connection

[Citizen]

Regarding cooling system hoses, is there any kind of sealant that can be used to “assist” standard type hose clamps?

I have one location where a brand new hose coupled with the coolant pipe does not want to seal with just one hose clamp. The one clamp is tightened enough I think, without doing damage to the pipe. This is near the LF tire. I suspect it is because the tube may not be perfectly round, but I dunno...

IMG_20190418_082001971.jpg

Thanks.

...

[FABombjoy]

Hairspray.

I'd be surprised if the tube was out of round. It would be challenging to crush one of these tubes in a way that wasn't obvious, but you never know!

But I would pull the hard line and check it for mineral buildup and pinholes, especially pinholes as you'll have a helluva keeping a good seal around a pinhole.

You can get quite a scale behind the pipe beads which can prevent a proper seal. If I pull a hard line pipe I always remove scaling and shine up the end of the tube with sandpaper.
This isn't something in your standard internet how-to as most cars don't have 22 rubber hose sections and 9 coolant hard lines

[David T]

The build-up of mineral deposits is the additive package trying to stop a leak. Do not try to stop the leak by over-tightening the hose clamp, you just wind up stripping it out. The way to fix the leak is to remove the hose, remove the build-up, and inspect for pinholes. If you find pinholes just slide a longer hose over them. You really should not need anything to seal the hoses but to slide the hoses on it makes it easier if you dip the hose in anti-freeze to lubricate them first.

[Citizen]

Thanks guys. I was able to remove some sediment, adjust the hose position a bit and it quit leaking from that point.

But...it turns out I still had a different leak that I didn't see before. After sticking my head close in the wheel well, I saw that the pipe (PN-105989) was warn through, apparently by the steering linkage. It went far enough into the pipe to create a pin hole.

Here is what it looks like with the coolant coming out:
DeLorean-Coolant-Leak-0.jpg

And here is what it looks like with no pressure:
DeLorean-Coolant-Leak-1.jpg

Can an aluminum pipe like this be welded? Or am I looking at buying a new one?

T.

...

[Bitsyncmaster]

That looks like a lot of spline showing on the steering shaft. Did something move that is causing that.

Yes, aluminum pipe can be TIG welded.

[Citizen]

That looks like a lot of spline showing on the steering shaft. Did something move that is causing that.

Agreed, looks like a lot of spline showing. But nothing's changed that I know of. I am the only driver, and have had the car for some 13+ years, and know of nothing to cause a change in that area. Probably it has been rubbing for all that time, and maybe more, just has never been caught.

Might be a good idea for everyone to take a look at their steering linkages, and see if it is rubbing against the coolant pipe like this, next time they are under the car. I'd be curious to know if and how many others have experienced this. Could be an engineering flaw.

Yes, aluminum pipe can be TIG welded.

Great, I'll start a search for someone that can do a weld for me. When I get it fixed and back on the car, I'll try to adjust or twist it such that it has ample clearance from the steering linkage.

Thanks again!

Thomas

...

[Bob635]

Can an aluminum pipe like this be welded? Or am I looking at buying a new one?

T.


Yes, the aluminum pipe can be welded. In fact, I have had a number of them welded together to eliminate all the little rubber hoses. I did this for the IronMan Delorean project.

Bob