Going through my box of parts from the PO and came across this ... thing. What is it and what did it do?
TIA!
IMG_8204.jpgIMG_8203.jpg
Location: Near Philadelphia
Posts: 140
My VIN: 1596
Club(s): (DMA)
Going through my box of parts from the PO and came across this ... thing. What is it and what did it do?
TIA!
IMG_8204.jpgIMG_8203.jpg
Location: Florida: Pinellas County
Posts: 2,110
My VIN: 5003 Never placed Concourse
Club(s): (DCF)
The plate is supposed to bolt the transmission on the driver side (#101075) where the flywheel is. It is a 'pickup' that was supposed to be there for diagnostic purposes but no one knows if the flywheel actually has anything for this to read (it would have been perfect, if it did indeed work, to use for EFI!).
-----Dan B.
Location: Near Philadelphia
Posts: 140
My VIN: 1596
Club(s): (DMA)
Thanks. That's curious.
If I can find the other half of the wire, I'll attempt to reconnect it. If not, I'll just clean it up, paint it and bolt it back on without the wire, I suppose.
There's no point in connecting it. It does nothing
On my car I clipped the wire and left the plug head in place.
Luke S :: 10270 :: 82 Grey 5-Speed :: Single Watercooled T3 .60/.48 :: Borla Exhaust :: MSD Ignition :: MS3X Fully SFI Odd-fire EFI :: DevilsOwn Methanol Injection
Location: Florida: Pinellas County
Posts: 2,110
My VIN: 5003 Never placed Concourse
Club(s): (DCF)
Agreed, unless you want it for originality or whatever then install /connect it. Otherwise, that plate makes it a PITA to remove the engine/transmission and the sensor isn't useful for anything. When I had that engine, I removed the plate with the pickup & the whole diagnostic plug completely.
Last edited by dn010; 04-29-2019 at 12:31 PM.
-----Dan B.
Location: Near Philadelphia
Posts: 140
My VIN: 1596
Club(s): (DMA)
What about the flywheel inspection protection plate, which is also in the box. Does that serve a purpose?
delorean-flywheel-protection-plate.jpg
Location: Florida: Pinellas County
Posts: 2,110
My VIN: 5003 Never placed Concourse
Club(s): (DCF)
It is also just another protective cover for the flywheel, you remove it to check the condition of the teeth, etc. I haven't had that, or the other plate installed for 17 years and have not had any issues, no debris got in, etc.
-----Dan B.
Location: Illinois
Posts: 2,440
My VIN: 11408
Club(s): (DMWC) (TXDMC) (DCUK) (DOI)
i tried to order that inspection plate back when i had my prv and Dave S. talked me out of it! haha!
Supercharged 5.3L LS4 + Porsche 6spd
[email protected]
lsdelorean.com
I am not affiliated with Delorean Midwest in anyway.
Probably one of my favorite things about DMC or at least dmcmw. They seem completely honest about what parts you need. Dmcmw inspected my car after I bought it and went through and broke down everything into how critical it was and if it was an easy diy job. Big difference from jiffy lube trying to scam me into changing my power steering fluid on my first oil change with my first car.