Just getting around to installing but can’t find a pic of which way the float goes on.Its not in the instructions that was provided . Thanks
Location: NY/PA
Posts: 51
My VIN: 17007
Just getting around to installing but can’t find a pic of which way the float goes on.Its not in the instructions that was provided . Thanks
Location: Austin MN
Posts: 583
My VIN: 03500
The float would have to stay floating on the surface of the gas in the tank. What your photos show does not look correct since the float would tilt at an angle in the gas. The arm on the resistor must have another way to install it.
Dave M vin 03572
http://dm-eng.weebly.com/
Location: Northwest Florida
Posts: 324
My VIN: Midproduction
The bent end goes into the rotary arm.
In line with the sender arrow- all the way until the clips engage
Location: NY/PA
Posts: 51
My VIN: 17007
Damn didn’t think of that one THANKS!!!
Location: Austin MN
Posts: 583
My VIN: 03500
Was in a rush didn't notice the peg wasn't in the hole.
Whoops
Dave B.