Here's the log and tune from yesterday. I ran with VEAL on the first leg, smoothed it out a bit, then ran without VEAL on the way home. This log and tune are from the trip home.
The fuel table is still a bit bumpy. I'm not actually sure if that's OK, or if I want it to be perfectly smooth. I know what an idea table is supposed to look like, but I'm not sure if that is actually you have in the real world.
I had no stalling, although the RPMs dropped to the 500s at times. I have A/C idle up working, and I did drive with the A/C on for most of the trip. A/C idle up is set to turn off the A/C below 700 RPMs, which may have saved me a few times, but I'm not totally sure.
I'd like the idle not to drop quite that low, but I don't really know how to stop that.
Also, I'm considering an accelerator pedal position sensor built from a pot, a 3D printed case and a rod or two. Mostly for logging purposes, but maybe I'll be accurate enough for MegaSqurit to use it. I just have to figure out exactly how I'm going to mount it.
Tune: CurrentTune.msq
Log (zipped; it's over an hour of driving): 2019-09-01_16.55.41.msl.zip