Just getting around to installing but can’t find a pic of which way the float goes on.Its not in the instructions that was provided . Thanks
Location: NY/PA
Posts: 51
My VIN: 17007
Just getting around to installing but can’t find a pic of which way the float goes on.Its not in the instructions that was provided . Thanks
Location: Austin MN
Posts: 583
My VIN: 03500
The 1st pic where it goes off to the side is how I put mine. It will occupy the same space as the original fuel sender.Originally Posted by Dontilgon
Also there is a few YouTube videos of these being put in that my help.
Dave B.
Last edited by WHO1DMC; 09-15-2019 at 08:16 AM.
Location: Leonardtown, MD
Posts: 9,006
My VIN: 03572
The float would have to stay floating on the surface of the gas in the tank. What your photos show does not look correct since the float would tilt at an angle in the gas. The arm on the resistor must have another way to install it.
Location: Northwest Florida
Posts: 324
My VIN: Midproduction
The bent end goes into the rotary arm.
In line with the sender arrow- all the way until the clips engage
Location: NY/PA
Posts: 51
My VIN: 17007
Damn didn’t think of that one THANKS!!!
Location: Austin MN
Posts: 583
My VIN: 03500
Was in a rush didn't notice the peg wasn't in the hole.
Whoops
Dave B.
Posting Permissions
Reply With Quote
Dave M vin 03572
