Luke S :: 10270 :: 82 Grey 5-Speed :: Single Watercooled T3 .60/.48 :: Borla Exhaust :: MSD Ignition :: MS3X Fully SFI Odd-fire EFI :: DevilsOwn Methanol Injection
Location: Western MASS
Posts: 32
My VIN: 16064
Location: Western MASS
Posts: 32
My VIN: 16064
Does anyone have the resister value to pull up value from Banner unit?
Almost current wiring is attached.
Thanks
Here you go. Part number is in the picture.
Last edited by powerline84; 05-07-2021 at 03:31 PM.
My You Tube Channel
https://youtube.com/@timelesssteelga...fOpBaYJDtDlkQx
My Build
http://dmctalk.org/showthread.php?14...-s-20-year-nap
Disregard that last post here are the correct resistors . You only need one. Screenshot_20210507-142906.jpgScreenshot_20210507-142944.jpgScreenshot_20210507-142952.jpg
My You Tube Channel
https://youtube.com/@timelesssteelga...fOpBaYJDtDlkQx
My Build
http://dmctalk.org/showthread.php?14...-s-20-year-nap
I hate this forums picture process...maybe this one will be easier to see Screenshot_20210507-142944~2.jpg
1/2 watt 1k ohm resistor
My You Tube Channel
https://youtube.com/@timelesssteelga...fOpBaYJDtDlkQx
My Build
http://dmctalk.org/showthread.php?14...-s-20-year-nap
Screenshot_20210507-142906~2.jpgScreenshot_20210507-142952~2.jpg
Also make sure eyou check in the manual and make sure your mega squirt box is set up for the right ignition. They are not setup from diy auto tune to run this ignition as default. So make sure you have the right pots moved to the right spots.
Last edited by powerline84; 05-07-2021 at 03:44 PM.
My You Tube Channel
https://youtube.com/@timelesssteelga...fOpBaYJDtDlkQx
My Build
http://dmctalk.org/showthread.php?14...-s-20-year-nap
Location: Western MASS
Posts: 32
My VIN: 16064
I added the 1K resister to the signal(bk) to +(bn) connection on the Banner unit. Still not showing up on RPM on Perfect Tune gauge or computer.
I will be checking square wave on output and RPM output pulse from MS tomorrow with Oscope.
Any other checks or changes would be helpful. I did not see hardware changes to MS in manual.
Thanks Jimmy for all your help. I know I am super close.
I suspect your ingition pots aren't right in the mega squirt box itself. Are you saying you verified them? Or that you couldn't find out how in the manual.
My You Tube Channel
https://youtube.com/@timelesssteelga...fOpBaYJDtDlkQx
My Build
http://dmctalk.org/showthread.php?14...-s-20-year-nap
Location: Western MASS
Posts: 32
My VIN: 16064
I will be going through it again this morning but didn't see where I needed to change anything from when I first assembled. I probably missed it.