FRAMING JOHN DELOREAN - ON VOD www.framingjohndeloreanfilm.com
Results 1 to 5 of 5

Thread: PRV engine

  1. #1
    Owner of #1537
    Join Date:  Jan 2020

    Location:  San Antonio TX

    Posts:    13

    My VIN:    01537

    PRV engine

    Hello all,
    I'm looking for a V6 PRV for my Delorean. Anyone have one that they're looking to send off to a good home? Almost any condition will be considered, I will handle transportation.
    Best regards,
    Brent V.

    1981 DMC-12 #01537
    1992 3000GT VR-4

    Instagram: the_road_to_88mph

  2. #2
    Administrator Ron's Avatar
    Join Date:  Jun 2011

    Location:  North GA

    Posts:    5,425

    Club(s):   (SEDOC) (DCUK)

    Missing Post(s)?

    Please review the Sticky titled "***-SECTION-RULES-***-Please-READ-BEFORE-POSTING-***".

  3. #3
    Junior Member
    Join Date:  Aug 2018

    Location:  Baltimore, MD

    Posts:    11

    My VIN:    5269

    Quote Originally Posted by Team#1537 View Post
    Hello all,
    I'm looking for a V6 PRV for my Delorean. Anyone have one that they're looking to send off to a good home? Almost any condition will be considered, I will handle transportation.
    Ive decided to do a Motor swap in my car. I am going to have an original full clean motor (including stock exhaust) and matching 5 speed manual trans with only 21k miles out of an Oct of 81 car.

    Id probably be will to let it go now instead of later for a good price.

    Motor has had the following maintenance performed in the last 4 years with records to go with all upgrades.

    ENGINE:
    Water pump, alternator, starter, cold start & fuel injector cleaning. Fuel distributor & warm up regulator replacement. Vacuum line kit, fuel regulator shimmed, Rear Main Engine Seal. Major tune up kit installed (plugs, wires, ignition distributor, valve cover gaskets). Intake manifold was removed, valley cleaned, Y-pipe in valley was removed, cleaned w/New Gaskets. valley coolant tube run replaced, and intake / throttle gaskets replaced on reinstall. Recently purchased NOS lambda probe. Everything with new hardware on replacement.

    McKeen microcontrolled idle Ecu and Solid State RPM Relay would be included

    TRANS:
    clutch & axle seals have been replaced.

    Extras: Id included a dwell meter and an exhaust gas analyzer as well for tuning the air fuel ratio.

    (I have redone to top Dmc decal and added a intake ram since these photos were taken.
    E26F3590-B2CB-42AC-9539-51E220D22D95.jpg348D846E-29EC-4CB4-9641-8E3E95CFEAC0.jpg

  4. #4
    Junior Member
    Join Date:  Aug 2018

    Location:  Baltimore, MD

    Posts:    11

    My VIN:    5269

    Quote Originally Posted by Team#1537 View Post
    Hello all,
    I'm looking for a V6 PRV for my Delorean. Anyone have one that they're looking to send off to a good home? Almost any condition will be considered, I will handle transportation.
    Updated photos
    DAAFF639-4D2E-4A96-A5BE-C3B9FF701D4C.jpgE6894F50-8588-4342-BBCF-6F1C74AB017C.jpgC87C3A32-3688-4ECB-B7B5-0A3B819345B5.jpg

  5. #5
    Member
    Join Date:  Feb 2019

    Posts:    77

    I have one available from a 9/81 car with 19k miles. PM me for details.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •