No Start

[David T]

A common failure point for both of your problems could be bad connections at those bulkhead connectors. The taillight circuits and the engine circuits both go through them. If the cover was missing at some point the connections can get corroded and become intermittent. Clean them all up and make sure each pin grips tightly on it's mate. You should not have to replace the wiring, just clean up some connections.

[dn010]

Did you happen to maybe miss post #8 where I already said all of this?

A common failure point for both of your problems could be bad connections at those bulkhead connectors. The taillight circuits and the engine circuits both go through them. If the cover was missing at some point the connections can get corroded and become intermittent. Clean them all up and make sure each pin grips tightly on it's mate. You should not have to replace the wiring, just clean up some connections.

[FLYBOY]

Yeah, Didn’t see that post
I did do that once a few years back already but I do it again probably the culprit
Thanks



Sent from my iPhone using Tapatalk

[dn010]

That post was intended for David.