FRAMING JOHN DELOREAN - ON VOD
www.framingjohndeloreanfilm.com
-
Senior Member
SPAX washers
I probably bought one of the first set of SPAX shocks out there. It was many years ago, but they were "recently" installed. I understand I need to replace the washers as they were to thin. But according to this picture compared to what is sold now, It looks like the bushings are larger for the front shocks also, and the middle washers are just thrown away? Do I need to replace the washers on the rear shocks as well?
Sent fra min H8324 via Tapatalk
Svein Apeland
1981 DMC DeLorean DMC-12, VIN: 01598. Gas flap hood, manual transmission, black interior, wide stripe, galvanized frame, Spax shocks and UK club exhaust.
x1973 Plymouth Road Runner
x1979 Pontiac Firebird Trans Am
x1975 Chevrolet El Camino
x1974 Plymouth Satellite Sebring
x1966 Lincoln Continental
x1983 Porsche 944
x1982 Porsche 944
-
DeLorean Club UK
This looks exactly the same as an email I replied to this morning.... The "new way" of doing the fronts, is to do them the same as the rears have always been. So you already have the "new style" rear setup. If you want to match the fronts to the rears you just copy that - i.e. it goes (from bottom to top):
Washer
Rubber
--frame--
Rubber
Washer
Nut
Nut
There are no middle washers with this setup.
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules