Easy to install. Worked like a charm. A little shorter than the previous model the PO had on the car, so you may need a hair extra length of wire to run to it. I simply had to reroute my existing wire - only took a few seconds to do so.
Location: Atlanta, GA
Posts: 228
My VIN: 6239 - November 81
Club(s): (SEDOC) (DCUK)
Easy to install. Worked like a charm. A little shorter than the previous model the PO had on the car, so you may need a hair extra length of wire to run to it. I simply had to reroute my existing wire - only took a few seconds to do so.
I got one too and am happy with it.
Location: sacramento
Posts: 1,415
My VIN: 1768
Club(s): (NCDMC) (DCUK)
I also just installed one but its much longer than the stock one was, still I think it works better than the the old original one did.
I purchased one of Hervey's pressure sender units for the gauge. It lasted about 4 months before going out
Hopefully I just found the bad one in the lot.....
You can't buy happiness, but you can buy a DeLorean and that's sort of the same thing....
Location: Northern Michigan
Posts: 1,147
My VIN: 1880
Club(s): (DCO) (DCUK)
It is a Corvette part that happens to work in the DeLorean. You just need to make sure you get the 80 psi version.
You can buy them for less than $10 on RockAuto:
http://www.rockauto.com/en/moreinfo....1041208&jsn=13
Patrick C.
VIN 1880