I'm 99% complete with my auto to manual conversion for #2203. However I cannot figure out how to route the crossgate cable correctly. I know it's critical to drill the hole for the cable in the correct place for the shifter. I'm fairly sure I did that part well. However, I can't find any info on how it routes through the frame and where it is intended to exit the frame on the transmission side.
I have it installed and hooked up to the transmission and the shifter, but it's completely bound up. The cable appears to do an S shape inside the frame. It was incredibly difficult to install, it almost seemed like the cable was too long for the inside of the frame.
Am I doing something wrong here?
Any help would be greatly appreciated!
Jayce
82189487_10220485601145004_7503114547545027317_o.jpg103252500_10220485613465312_6710809569948937674_o.jpg101680862_1550717408442113_2989840758721205577_n.jpg