Did you check to be sure the three brass screws are fully seated/closed?
Location: Florida: Pinellas County
Posts: 2,109
My VIN: 5003 Never placed Concourse
Club(s): (DCF)
Did you check to be sure the three brass screws are fully seated/closed?
-----Dan B.
No, where are those located? Can you reply with a photo?
I've attached a photo of the wide needle swing I'm getting on the dwell meter. Any ideas as to how I might remedy this?
https://youtu.be/v_fyilPK32A
Posts: 301
My VIN: 02855
Club(s): (NCDMC) (DCUK)
Location: Northern NJ
Posts: 8,581
My VIN: 10757 1st place Concourse 1998
Things that can affect the dwell;
Idle speed
Vacuum leaks
Contaminated O2 sensor
Worn ignition system
Dirty, leaky, bad pattern fuel injectors
David Teitelbaum
Posts: 159
I’m picking the injectors are dirty. Unless all spray an equal volume and spray pattern the ECU will chase it’s tail all over the place.