Wiper control module

[cis6409]

Hi guys
Just trying to tidy up my wiring routing for under the steering column and inertia switch etc.

At the moment it's just cable tied to the lambda counter loom and it's all just hanging.

Can't seem to find where the wiper control/logic box bracket is supposed to be mounted.

There does not seem an obvious place to locate it.
Have checked the manual but the pic is vague just says attached to underside of dash on driver side.. but where?

There is 3 speed clips attached but again can't see where they might go.

Does anyone have a pic of it installed in the proper location or any other ideas?

Many thanks
Shane

[WHO1DMC]

Hi guys
Just trying to tidy up my wiring routing for under the steering column and inertia switch etc.

At the moment it's just cable tied to the lambda counter loom and it's all just hanging.

Can't seem to find where the wiper control/logic box bracket is supposed to be mounted.

There does not seem an obvious place to locate it.
Have checked the manual but the pic is vague just says attached to underside of dash on driver side.. but where?

There is 3 speed clips attached but again can't see where they might go.

Does anyone have a pic of it installed in the proper location or any other ideas?

Many thanks
Shane

Hope this is a help to you.


Dave B.

[Rich]

And this.

Item 3, wiper module, is shown as it is in that photo screwed to left side of Item 1, Plate Support.

[cis6409]

Thanks guys that's great!

Cheers
Shane

[cis6409]

I've got the plate refitted
Great to finally have it in the correct place and not hanging down..
One other question the flasher relay is supposed to be attached to that aswell but instead of the relay mounted to the bracket the 3 pin electrical connector is fixed to the bracket and the relay is pushed on and off instead of the connector.

All that's there is a small pozi drive black screw. Is there a way of securing the connector to the bracket?. I've seen it another pic on the net but it's not clear can't make out how it's done?

Thanks
Shane

[Ron]

The screw goes through the socket, and it holds the flasher unit. See Rich's link (#3) above.

[cis6409]

O I see now, excellent thanks!


Shane