What about the Shroud of Dunmurry
https://www.instagram.com/p/B5gDdnCg8zG/
Shroud of Dunmurry.jpg
What about the Shroud of Dunmurry
https://www.instagram.com/p/B5gDdnCg8zG/
Shroud of Dunmurry.jpg
Jeff
#6313 (lic: DMC-EV Texas), 25k miles, 100% leather, touchpad, 100% LED, dimmable LED dash, remote door lock & Elvis mod, all A/C vents in kneepads, wedgectomy, escutcheon velcro fix, GM door chimer, custom arm rest/storage/controls...
Jeff
#6313 (lic: DMC-EV Texas), 25k miles, 100% leather, touchpad, 100% LED, dimmable LED dash, remote door lock & Elvis mod, all A/C vents in kneepads, wedgectomy, escutcheon velcro fix, GM door chimer, custom arm rest/storage/controls...
Sample (zoomed in on just a segment). This is the area of the trailing arm attachment location.
I can't attach the whole file (too large probably)
DeLorean Frame zoomed in 1.jpg
Jeff
#6313 (lic: DMC-EV Texas), 25k miles, 100% leather, touchpad, 100% LED, dimmable LED dash, remote door lock & Elvis mod, all A/C vents in kneepads, wedgectomy, escutcheon velcro fix, GM door chimer, custom arm rest/storage/controls...
Here's the link in case anyone is interested - Frame drawing in DropBox
If it doesn't work for you let me know.
To test the "uselessness" of the drawing, I took two baseline measurements off the rear of the actual frame, then measured the pixels for these same dimensions shown on the drawings (using GIMP). I then calculated the 'scale' of the diagram (in the X and Y dimensions). I then read off the pixels for a distance across the front of the frame, then calculated the measurement. When I checked the distance for that same measurement off the actual car - it was off by only 1/16th inch compared to the calculated value. That's probably a smaller error rate than you'd get by people physically measuring the frame - given the potential for measurement error and variances in the dimensions from car to car.
I measured 0.013214 inches per pixel, or 75.677 pixels per inch - your mileage may vary
DrJeff
Jeff
#6313 (lic: DMC-EV Texas), 25k miles, 100% leather, touchpad, 100% LED, dimmable LED dash, remote door lock & Elvis mod, all A/C vents in kneepads, wedgectomy, escutcheon velcro fix, GM door chimer, custom arm rest/storage/controls...
A couple of chassis-related drawings here, a lot of them with dimensions:
https://drive.google.com/file/d/1E3zlKxvqz30belIeJnSHLJV2OdW0zdGy/view?usp=sharing
Some of the drawings are stamped "for discussion only" so those are most likely not valid.
I've extracted everything to a shared directory, hope it helps:
https://drive.google.com/drive/folde...F7eqdvF5GMsf7j