Hi folks-so the tank on this '82 DMC I'm restoring had fuel sitting since 1993, and it was pretty much varnish. For the most part, I got the tank pretty clean by siphoning it out, and then soaking the tank in dishsoap+water. There appear to be two rubber hoses that live inside the tank, and they actually seem pretty pliable, but I'm assuming I should replace these, no? Is there a configuration diagram for these, or pics, or a description anywhere? I've never seen this kind of system, with the hoses and the white plastic "web" moulding that lives inside the tank. Don't fully understand it. Thanks for any tips!
PS-I'm almost done with the breakdown portion of the job; the top end of the engine is stripped down, suspension and steering is out(new parts are here). Once I strip the brake MC/booster and clutch cylinders, that part is done. New radiator/fan assembly is in, and started to go back in with the cooling hoses. I'm getting a 4 post lift installed next week, so I had aspirations of finishing the job on it, but I haven't figure out how I'd get it ON there, since the car is currently on a dolly. nevertheless, progress is being made on getting this car back on the road in 2023!