Dave M vin 03572
http://dm-eng.weebly.com/
I have done more software work on my lambda ECU. First I think I had a bug causing my whole engine issues. But I continued work on the software and now I'm running it 4 times faster then my first units and I still don't get idle hunt. I will have to try an OEM lambda ECU to make sure I still get idle hunt with that.
So OEM changes the dwell from max to min in 8 to 10 seconds (speed of dwell changes).
My lambda now does that in 16 seconds or has a user jumper to change it to 32 seconds.
Dave M vin 03572
http://dm-eng.weebly.com/
Location: Reedsburg, WI
Posts: 4,026
My VIN: 5180
Club(s): (DMWC) (DCUK)
DENNIS
VIN 5180, Frame 3652, STAGE II, DM-eng Solid State Solutions (RPM Rly, Dm.Lt.Mod., Fan Fail Mod. , FAN Rly, HS.Rly) , HID headlights, SPAX user since 2009, Eibach springs, M Adj. Rear LCA's, DPNW poly-sway bar kit, DMCEU LCA Stabilizer link kit, DMCMW Illuminated door sills, Aussie Illuminated SS Shifter plate, REAL MOMO EVO Steering wheel, DELOREANA Extended View Side Mirrors w/ Heaters, DELOREANA LED Door Lights.
Now that I can drive my D for errands I probably start selling them pretty soon. Just want to make sure no problems.
I started writing up some info.
LAMBDA ECU
This ECU was developed to eliminate idle hunt caused by the stock lambda ECU.
I also added a status LED but so far you only can see that LED looking at the front of the ECU case. With the LED off it indicates the O2 input is high impedance which is normal the O2 sensor is cold or disconnected. In that state the frequency valve is running at 50% duty cycle (45 deg. Dwell). With the LED green it shows your FV dwell is between 35 to 45 deg. Dwell. With the LED flashing green, it shows the dwell is running outside that range. With the LED solid red, it shows your dwell is holding at the minimum or maximum dwell. A fast-flashing red indicates wide open throttle is on holding 55 deg. Dwell.
One owner had a suggestion. Put it in a smaller box so there is more room in the cubby for a speaker/amp. This could be done but would require a new PCB and I want to wait till a few owners are using it.
Dave M vin 03572
http://dm-eng.weebly.com/
Well here is good new. I just plugged in a stock lambda ECU and when it goes closed loop I still get the idle hunt. That is good news for me because my ECU does not do that.
Dave M vin 03572
http://dm-eng.weebly.com/
Posts: 16
Dave,
Do you think this would help the stage 2 guys?
Really only advantage is to stop idle hunt. My unit still holds the same 14.7 AFR which is all you can do using a narrow band sensor. Only thing that may feel a difference is my wide open throttle instantly goes to 55 deg. dwell where as the stock unit steps to 55 deg. from where it was.
My unit also performs the same testing function as the stock unit. Open sensor, shorted sensor and 1.5 volt battery tests.
If your looking for more performance (AFR 12 or 13) you can install a wideband sensor and feed that output as an analog into the stock lambda ECU or my ECU would also do the same.
Dave M vin 03572
http://dm-eng.weebly.com/