FRAMING JOHN DELOREAN - ON VOD
www.framingjohndeloreanfilm.com
-
Door lock module upgrade to control actuartors
-
-
replies'
No one has replied to my thread. good, bad , indifferent
-
Senior Member
Good work. Yes it works to have the relays ground the unused side so it can work with actuators or solenoids. You may want to replace the stock ground wire in the harness which is about 19 AWG to a 16 AWG. But it does work with my actuators without that wire improvement.
Last edited by Bitsyncmaster; 07-20-2023 at 08:05 PM.
-
reply
In all my Delorean internet browsing, I never ran into this modification. I intended for it to work with actuators only.
-
wiring
This modification only uses the two 12volt wires that went to the solenoids. No ground needed only polarity reversing.
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules